7.5 Design
Vacuum Type
This vacuum feels pretty well-built, though build quality does fall slightly short of higher-end iRobot models with a hollow-feeling housing. Otherwise, it's pretty similar to the iRobot standard, with dense rubber brushrolls, a three-armed side brush, and a centrally-mounted caster wheel. It has a top cover made of matte-finish bronze-colored plastic, which differs from the iRobot Roomba i3, which has a plastic top cover textured to look like fabric. There are three buttons on top of the robot: a big center one to start and stop a cleaning cycle, and two smaller buttons to send the vacuum home and have it spot-clean an area.
The vacuum comes pre-assembled, so all you need to do is set up the docking station, which arrives with a dirtbag already inside.
—
7.5 Design
This vacuum is pretty easy to maintain.
- Dirt Compartment: The internal dustbin comes out pretty easily, as you only need to press the release button on the side of the vacuum's body. That said, you should be careful when taking it out, as debris can spill out the back if it's quite full. You should empty it after each use by tapping it on the side of a garbage can and wiping any debris from the lid with a dry cloth. If necessary, you can wash it with water, but be sure to remove the filter beforehand. If you purchase the i1+ variant with the self-emptying base station, you won't have to empty its dirt compartment very often.
- Filter: The filter is located inside the dirt compartment. Clean it by taking out the dirt compartment, pulling out the filter, and tapping it against a garbage can once a week or twice a week in homes with pets. You shouldn't wash it with water.
- Brushrolls: The brushrolls are easy to access by lifting the brush cover on the bottom of the vacuum and pulling them out. You can remove any tangled hair or stuck-on debris by hand once or twice a month, depending on whether or not you have pets. Long hair tends to get wrapped around its outer bearings, not the brushroll itself, and they aren't especially hard to clean. That said, it can be tricky to put them back because they need to be properly aligned in their housing.
- Side Brush: The side brush is located under the vacuum and requires a Phillips-head screwdriver to remove. You'll need to clean it by hand once or twice a month, depending on whether or not you have any pets. It tends to collect a lot of long hair, but it isn't too hard to clear it away once you've unscrewed it from the vacuum's body.
- Wheel: You can remove the front caster wheel by pulling it out of the vacuum and then pushing it out of its socket. You should clean it twice a month by removing any tangled hair or debris.
- Sensors and charging contacts: The sensors and charging contacts on the vacuum and docking station should be wiped clean with a dry cloth once a month.
- Dirtbag: The dirtbag inside the docking station needs to be thrown away and replaced when it's full, which is indicated by a red light on the docking station. Thankfully, it's self-sealing, so you don't need to worry about a plume of dust being created when pulling it out.
Any part you can wash under water should be allowed to dry for 24 hours before putting it back in the vacuum.
—
3.0 Design
Bag Part Number 4640235
Filter Part Number 4639161
HEPA Filter Part Number 4639161
The iRobot i1 Plus incurs high recurring costs.
- HEPA Filter: You should replace the HEPA filter every two months.
- Rubber Brushrolls: You should replace the brushrolls every 12 months.
- Front Wheel: You should replace the front wheel every 12 months.
- Side Brush: The manufacturer recommends replacing every 12 months.
- Dirtbag: The dirtbag needs to be thrown away and replaced when it's full.
iRobot sells a 'Replenishment Kit' that contains three side brushes, a new pair of multi-floor rubber brushrolls, and three HEPA filters.
—
8.5 Design
Height
Width
Depth
Cord Storing
On-Board Tool Storage
Vacuum Rack/Station
The iRobot i1+ is pretty easy to store. Its base station is taller than that of the j7 variant of the iRobot Roomba j7 but has a similar horizontal footprint and is consequently easy to fit in a small nook. You can wrap up any excess length of power cord behind the base station.
—
8.2 Design
Bagless
Volume
Full Indicator
Bag Included
The iRobot Roomba i1+ can hold an impressive amount of debris. The external dirt compartment's capacity of almost two and a half liters is similar to a lot of full-size bagged canister or upright vacuums like the Miele Classic C1. An indicator light on the station lets you know when the bag is full or if there's an obstruction in the tunnel leading toward the bag. The app can notify you when the dirt compartment or bag is full.
—
Design
- iRobot Roomba i1+ robot vacuum
- Charging dock/bag emptying station
- Charging cable
- 1x HEPA filter
- 2x multi-surface rubber brushrolls
- 1x side brush (one already attached to the vacuum)
- Dirt compartments
- 1x dirtbag
- Easy Setup Guide/Warranty Card/Safety Information
—
10 Design
Cordless
Cord Length
Hose Length
Minimum Wand Length
Maximum Wand Length
Total Range
This vacuum's range is limited only by its remaining battery life, but it can't go up or down stairs.
—
8.0 Design
Total Weight
Weight In Hand
Carrying handle
This vacuum is quite portable. It weighs a little less than the iRobot Roomba i8+, but unlike the latter, it doesn't have an integrated carrying handle that would make it easier to pick up and carry around.
—
9.5 Design
Minimum Battery Life
Maximum Battery Life
Recharge Time
Recharge Dock
Battery Life Indicator
Removable Batteries
This vacuum has superb battery performance. It can run for about two hours on a full charge, though since it automatically adjusts its suction power in the presence of high concentrations of debris, its runtime won't be quite as long if it's cleaning a very dirty area. It can fully recharge in under 100 minutes, which is very fast by the standards of other robot vacuums. You can keep an eye on the vacuum's current charge level by monitoring the indicator light around the 'Clean' touch-sensitive button, which switches from solid white to solid red as the charge level drops.
—
LEARN ABOUT BATTERY
Design
Rotating Head
Power Adjustment
Self-Propelled
Headlights
Easy On/Off
Head Surface Type Adjustment
This vacuum has a few quality-of-life features. Like the iRobot Roomba i8+, it focuses on cleaning areas with a higher concentration of debris. However, you can't adjust its suction power manually.
—
Design
Brushroll
Brushroll On/Off
Removable Brushroll
Turbo Brush
Crevice Tool
Upholstery Tool
Soft Bristle Brush
Hard Bristle Brush
Extension Wand
Ceiling Fan Tool
Pet Grooming Tool
This vacuum has a single side brush that moves debris from the outside edges of the vacuum into the path of its main brushroll.
—
8.0 Performance
—
7.5 Performance
—
7.0 Performance
—
7.0 Performance
—
0 Performance
Maximum Hose Suction
Maximum Head Suction
Normal Head Suction
Setting Used For Normal "Clean"
Hose Diameter
The iRobot Roomba i1's real-world suction performance is poor. Like most other robot vacuums, its suction inlet is positioned too high above the contact surface to create a tight seal, so real-world suction measurements are low.
—
1.2 Performance
Maximum Hose Airflow
—
8.9 Performance
Bare Floor
Low-Pile Carpet
This vacuum isn't too loud. However, it emits a somewhat odd noise that almost sounds as though its motor is failing, which could be quite disruptive.
—
7.5 Performance
The iRobot Roomba i1 has good maneuverability. While it doesn't store a permanent map of its coverage area, it still relies on smart pathing to navigate, and as a result, it cleans in an organized pattern. Unfortunately, it can have a bit of trouble navigating around obstacles like chair legs or coat stands. It also has quite a bit of trouble climbing onto shag pile rugs and gets stuck on loose obstructions like rug tassels. Thankfully, the lack of a LIDAR sensor and its compact dimensions allow it to clean under most couches and chairs without too much difficulty.
—
0 Performance
Sofa Pickup Post Test
—
Performance
Anti-Allergy Filter (HEPA)
This vacuum does a great job of sealing in fine allergens thanks to its onboard high-efficiency filter.
—
4.0 Performance
Wood Cracks Post Test
This vacuum does a terrible job of clearing away debris in cracks and crevices. Like a lot of lower-end robot vacuums with less powerful motors, it doesn't exert enough suction force to draw out debris from deeper crevices, and its side brush is ineffective in helping to dislodge debris.
—
1.0 Performance
Stain Pickup Post Test
The iRobot Roomba i1 does a terrible job of dealing with dried-on stains. Unlike the Roborock E4, it isn't compatible with a mopping attachment for scrubbing away stains.
—
0 Performance
Wet Compatible
Water Pickup Post Test
—
9.1 Automation
Automatic Recharging
Automatic Bag Emptying
Pathing Algorithm
Physical Boundary Markers
Scheduled Start Buttons
Cycle Control Buttons
Navigation Control Buttons
The iRobot i1 has excellent automation features. Its 'Recharge and Resume' capability lets it resume a cleaning job from where it left off after returning to its docking station to empty its dustbin or recharge. You can also control certain functions with the trio of physical buttons on its top cover. The 'Home' button has it return to the base station, the 'Power/Clean' button turns it on and off and has it start a cleaning session, and the 'Spot Clean' button tells it to clean a small area. It's also fully compatible with Google Home and Amazon Alexa devices, which allow you to make specific commands using your voice.
—
7.5 Automation
App Name
iOS Availability
Android Availability
Software Boundary Markers (No Go Zones)
App Scheduled Start
App Cycle Control
Navigation Control within App
The iRobot i1 has a good set of in-app features. You can use it to schedule cleaning sessions for your home while you're away, check the 'Product Health' tab to see the replacement time for its filter, side brush, and brushrolls, and enable or disable various user and safety settings, like a child and pet lock. While the vacuum doesn't store a permanent map of your home, you can still see the coverage map it generates at the end of a cleaning session. However, unlike the iRobot Roomba i3, which received a substantial firmware update, you can't label rooms, add area dividers, or set custom cleaning settings for specific rooms.
—
